Promax HD Ranger + Manual de usuario descargar pdf (Pagina 93)

9-86 March 2015

1111111111111111111

► SatCR commands:

By means of function SatCR it is possible to control the devices of a TV satellite

installation that are compatible with the SatCR (Satellite Channel Router)

technology, which allows to concentrate downlink frequencies (slots) by an only

cable. By this way each user using a slot can tune and decode any signal present

in the satellite.

Connect the RF cable (see Figure 6) to the RF connector for the input

signal of the equipment.

Press the Spectrum key to access the Spectrum analyser mode.

Press the Settings key and select the satellite band.

Select the polarization (horizontal/vertical) and the satellite band

(high/low).

If necessary, enable the Supply output and select the supply voltage

for the LNB.

In the option SatCR, select ON to enable it. It appears the icon at

the top right corner.

Also in the SatCR option, select Configuration to access SatCR

parameters.

Figure 50. SatCR command screen.

The configuration window shows the options that user can modify:

number of slots, slot selected, device address, pilot signal activation

(when activating the SatCR device located in the headend, it emits a

pilot signal with constant level for each downlink frequency to

identificate available channels), selected satellite and frequency step.

In other box appears the frequencies corresponding to each slot.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 159 160

Sin comentarios

Promax HD Ranger + Manual de usuario Pagina 93